Open your complete ifrogz™ package,
Check your package contents for a Wrap, Band, and Screen Protection packet.
Check the contents of the Screen Package for a decal sheet and the clear protective Screen.
Carefully clean the surface and screen of your iPod™
Separate the clear sticker backing from the ifrogz™ Screen. When separated, the clear sticker is the piece with a white tab, and the ifrogz™ Screen is the piece without a white tab.
Place the ifrogz™ Screen with the adhesive side down over the front of your iPod™. If you need to adjust the Screen, simply remove it and reapply.
Press a hard card against the ifrogz™ Screen on your iPod™ and squeeze out the bubbles. Some bubbles over the click-wheel will not completely disappear because of the raised surface.
Remove the appropriate click-wheel decal from the decal sheet.
On this picture, the ifrogz screen protector is already on the iPod™.
Now insert the iPod™ with the ifrogz™ Screen and decal into the ifrogz™ Wrap through the top window hole.
Remove the connection screw from the (optional) belt-clip package. *Purchased separately.
Screw it onto the back of your ifrogz™ Wrap at the designated location.
The optional belt-clip should easily click onto the connection screw. The tab on the top of the belt clip enables it to be released from the screw.
Now place the headphone jack of your earbuds through the hole in the ifrogz™ Band from the smooth side.
Connect the earbuds with the ifrogz™ Band into the iPod™ headphone jack.
Lastly, pull the Band around the ifrogz™ Wrap and secure it along the groove in the Wrap.
Your iPod™ is now protected in style!
